Following my rear end shunt a couple of weeks ago, I sourced and painted a rear bumper and fitted a new crash bar.
The car was on my drive facing slightly downhill and from starting the job to finishing, it did not move was not switched on or anything. Removed the old bumper and crash bar, tapped out the wheel well, fitted new, connected reverse sensors and went to drive away, only to be greeted by three beeps, a flashing handbrake warning light and ABS/traction lights showing!!!
Tried connecting to the old sensors on the old rear splitter but no different, any ideas chaps?
a teaser
Moderators: water01, vwnutant, desertstorm