Any advise? Just went through loads of Hassel getting a set of Mercedes merak alloys for the Passat and the only bit I didn't check was the bloody bolt holes and there too small.
Is it safe/ok to bore the holes by 2mm to get them to fit? Any idea what sort of place can do it near bracknell/reading as drills are not usually my friend.
Mainly annoyed as I've gone through a lot of Hassel and friends/work colleagues putting themselves out for me to get these before my MOT tomorrow as I'm not sure all my tyres will pass.
God damn wheels!
they dont fit!!! really annoyed!
Moderators: water01, vwnutant, desertstorm