Straightening bent door hinges.

From 16v to vr6- Add all the information in here....

Moderators: water01, vwnutant, desertstorm

Post Reply
VolksKid83
B2
Posts: 204
Joined: Fri Aug 06, 2010 10:34 pm
Passat model: B3 GL, B5.5 2.0

Straightening bent door hinges.

Post by VolksKid83 »

So, following not one of the best months, i am currently sorting my Passat after being side swiped by a drunk driver.

I have sorted the new panels (front drivers wing and drivers door), and have them ready to go on with replacement hinges for the door (the door half). However the other half of the hinge is bent, as so:

ImageWP_002998 by Mathew Richardson, on Flickr

Compared to a scrap B3:
ImageWP_002969 by Mathew Richardson, on Flickr

So, has anyone straightened these successfully before? As it stands i believe i have three options:
1) Straighten these. I've had a crack today with a King Dick adjustable spanner and a length scaffold tube, they are better but nowhere near and the tool slips off now!

2) Replace the individual hinges, doable however i anticipate getting those perfectly square difficult. Plus not sure if my migs up to doing such deep welds!

3) Replace the outer skin of the A-pillar from a donor with the hinges unmoved. Suggested by a local Mk2 Golf specialist, however looking at the many skins and spot welds it seems alot of chopping, welding and disturbing on a rot free structural area!
03 B5.5 Passat 2.0 Wagon - Fathers
91 B3 Passat GL TDi Wagon -The Daily
91 Polo GT Coupe - Daily No.2
83 Polo Formel E Bready - The Waiting Project
81 Golf Cabby GLi - On the road project!
76 Triumph Stag - Home Weekend Car

This topic has 8 replies

You must be a registered member and logged in to view the replies in this topic.


Register Login
 
Post Reply