UKPassats

Is it worth swapping out a 5 speed box for a 6 speed? The box in question is a frk code which Iam under the impression is the correct one for a 1.9tdi? Iam running a fair amount more power and torque than stock and am under the impression my dmf may be on its way out again after about 18 months of u...

Sell. Me the interior if you sell that car mate

Is there a particular brand I can use from a motor factors etc as Iam not really near a vw or tps

Is there a particular type of pas fluid I should use in my 05 b5.5?

Also does anyone know if non w8 brake lines are the same as w8 ones on the front

ms51ves3 wrote:Check out my thread on fitting footwell lights into the interior lighting circuit. Solution is the second to last post.

Clicky

You can tap into the plug that lives between the CCM and interior light in the passenger footwell.

Spot on thanks

Ah OK Iam trying to do leds puddle lights in the mirrors so want them to come on with the main light when you unlock the car ect

Can someone point. Me in the right direction to add extra lights inside the car when the main roof lights comes on?

Basically what wire do I tap into and where is it?

Cheers

Chris

I noticed absolutely nothing when I done the vac simplify other than less pipes in the engine bay

Is there a way to make the brake light at the top 2 bulbs so the light is a full circle?
I get it's not strictly legal as the brake light and fog would be too close.

Cheers

I'am i right in thinking it's
Stop/tail
Tail
Tail
Tail/fog

For the rear lights?

Hello troops

Could someone do me the kindest favour and tell me what bulbs fitment and wattage I need for the rear lights on. 5.5 estate

Thanks

Chris

If you used a kuftec loom then that's how there are meant to. Be mine do the same

Have a look here http://www.audifans.net/ftopict-14357.html

Left hand side of the engine as you look at it

That's the fuel temp sensor mate

The coolant temp sensor in on the other side of the cylinder head and round the back

checkmate123 wrote:sitting length ways oil filling top is towards windscreen

I didn't mean the engine they only go in one way

Where is the coolant temp. Sensor you tried to change?? As you say it's not where it's supposed to be

It should be round the back of the cylinder head

Where is it now sitting?

As my 5.5 the is on 160k and is on the factory side engine mounts I want to. Swap them out as I have a feeling in the car that the engine and box are slopping about during take off and gear changes All I want to know if 1.8t engine mounts are the same as the tdi ones as I want to fit the o34 motorsp...

What's the difference mate?

You can use mere sl500 discs which are drilled and cost 160 for a pair from merc and require a minimal amount of machining to fit Wheel speed sensors uses the stock ones just wrap a bit of tape round them to make then a tad bigger so they push fit just like the standard ones And they look Amazing wa...

If the engines lifting up when pulling away how can that be clutch related the clutch doesn't hold the engine in It most likely down to the snub mount fitted right at the front of the engine they are made out of a softish foam which get softer over time replace this with one out of a v6 tdi which is...

Looks good mate where did you get it

What's the thing on the bonnet mate looks good

Ok so you could use new foams then did they come with bulb holders

Has anyone used the pattern rear light for a. 5.5 estate off eBay?

Are they any good?