UKPassats

I'm not going to have my posts interfered with anymore And everyone here should know that their freely given posts from the knowledge they have are subject to censorship So, since also I've sold my Passrat due to all the lies from paid liars that are VAG Group -- I'm outa here -- and you can censor ...

You havn't said whether you want Navi or not?
And what about SD Card, DVD, USB, reverse camera, sub woofer, aux outputs for slave amp, MFSW control, MFD, DAB?
You'll have to be more precise about what options you want to decide "what's the best".

74% remaining. My thoughts were that this was too low for auto stop even though there is lots of life remaining. If you have a battery management system that's a slave/subsystem of the CAN Gateway then it might be worthwhile going into Long Adaptation - Size and see whether your Start-Stop will ope...

I didn't think the resistor was necessary if you have a single igniter airbag system. Anyways, I'd already done the deal with Hazzy Dayz to buy and have everything installed but he (who's well experienced in MFD and MFSW upgrades) wouldn't do it to allow install a Golf Mk V flat-bottomed style wheel...

What 74% expired life, or life remaining? If <25% life remaining it may be that it's being picked up as lower than that needed to provide BlueMotion services

In addition to jasimog's reply, yes. There could be a code showing in VCDS.

The codes given are identical to the codes given (converted from hex) in a Climatronic system.
PM me an email address for my help .doc. Also gives change out details for G263

I will be protected exactly as designed as there still an working airbag all fully connected up and working and this will not invalidate any of my insurance! And I think I will keep the wheel thanks and I told him to do the mod! Do you want to go and tell everyone else on here that has already done...

The whole 2.8 inch touch screen has gone off just a dead blank grey screen. Perhaps a fuse The MFD is the small screen between your two dashboard dials. If that's gone absolutely blank with nothing being displayed wouldn't think it's anything to do with your IPhone. There's a unit underneath your p...

he resistored one on the circuits to remove the airbag fault that would have been created by putting a single stage on Putting a resistor in circuit to defeat the Air Bag sensor that one of the igniter circuits has not been connected means that in the event of a crash you will not be fully protecte...

That Exide you have is definitely a "Start Stop" battery -- here's an equivalent in case you need from Tanya who's known to be price competitive https://www.tayna.co.uk/H15-Varta-Start-Stop-Plus-AGM-Car-Battery-605901095-P8824.html There are Exide date codes but I don't know where they're ...

You say your screen has "turned off". Do you mean the whole MFD has stopped, i e it's not giving anything at all like no indication that doors are open etc? Or do you mean that only your 'phone numbers, calling, etc have stopped being displayed? Did you upgrade to an IPhone 6 or was it the...

Add to all this Derv-hating (the latest council fad, but this time justified) you have the VW brand image that's now heavily tarnished with all the lies :^o that they've been telling over the years. Serve 'em right... I was lucky to sell my '06MY 2.0L tFSI -- to someone who knew what they were buyin...

Very nice then B) But take care if you have dual airbag system. The fitter might've disabled one of your igniter circuits. I've got dual airbags and was going to buy a Mk V (flat bottomed similar to yours) But the fitter couldn't do it coz of my dual airbag system -- so ended up with the eight-butto...

Well, was it a pothole or was it the edge of the road? If pothole it's the traffic authority's responsibility If edge of road then it'd be where the road ends and the adjacent private land begins Passing point laybys are the traffic authorities' responsibility Did you change two speed sensors or onl...

Your pic doesn't look like a B6 ('05 to '08MY) More a B7 or CC from dash
What year is your car?

This on a B5.,5 or B6? If B6 what year? Miles?

ABS sensors pick up rotation of the ABS disks attached to your hubs. These might've been damaged / warped
Did you change both sensors?

Local authority road? Sue

http://www.volkswagen.co.uk/technology/ ... ms/rns-850

The aperture to surround would be different

I assume you mean the BlueMotion isn't operating? That does depend on good battery condition. And a battery of the correct type (that can be recognised by the car's battery control module) Varta do them. But they're not cheap If your car's got either the correct battery that's now too old (five year...

For my Pioneer head unit I use a Dynamic Sounds DS-VW002 adapter like this one: http://r.ebay.com/5rgYOL. It supports a multifunction steering wheel if you have one, but it still works fine if you don't. See the Connects2 website. They do sell directly. I had their adapter for my MFSW for my JVC in...

Latest androids, like the RNS510, require you to have at least an "F" version of CANbus module I'm a complete noob to the CANbus thing. Is there an easy way to check my version? Mine is a 2010 (10) Highline model, so hopefully has a more recent/higher version. The CANbus module is upside ...

Latest androids, like the RNS510, require you to have at least an "F" version of CANbus module

Tell us more. Is the door check strap lever loose? Can you feel up / down movement of it?
Is the movement more in the "A" pillar than the door?

Aha, you don't mean door warning lights as on dash. You mean "puddle lights" at the bottom of the doors, then. Bit slow at that time of the morning :) I've got the SEL so mine were already there. I just updated to LEDs: white down lighters with reds facing aft. They come on whether the sid...

May be nothing for it but to remove door card and see what's come adrift IMO Sometimes the ball at the end of the Bowden cable comes out from its claw clasp. This is due to the Bowden cable inner sticking and not moving back and forth in its outer smoothly. There's a dealer up-rated part for replace...

So it's only the two rear pax doors that don't show on the MFD graphic when open? I'm trying to see whether there's any pick up via another sensor for the rear doors open Wiring a rear door sensor to the front sensor would mean the graphic wrong for rear door open -- it would show :roll: front door ...